CASE STUDY 3 – ASSESS AND / OR GIVE FEEDBACK FOR LEARNING

Written by

in

Giving feedback to students during exhibition install is essential, but can be fraught. This period is ‘the sharp end of the wedge’, with a looming time crunch of a few days or hours on work that may have been developing for up to three years for the student, in the case of a degree show. There are three categories of feedback I identify in an install: necessary, practical and curatorial. Necessary covers elements of safety and accessibility; for example ensuring electrical cables are covered and not trip hazards, or that suspended work does not block a fire escape. Practical covers how to install work, especially when the student’s preparations have not worked in reality. Some real-world examples are: when power sockets that were planned to be used have not been working; when a student’s picture wire is not anchoring to the wall; or when a room in summer has more natural light than the student expected and this is disrupting a projection. Finally, curatorial feedback is more questions of aesthetics and placement, and in install is most common due to how different student’s work in a space sits together and coheres. 

For all of these, especially necessary feedback, Its important to assess if the student has understood and taken on board the feedback. Its possible to just act and solve identified problems, but this has little educational value. I always find that a Socratic approach is best: asking the student questions about the topic requiring feedback, to find out what their understanding of the issue is, and once they are drawn to the root cause, if they know how to solve it. Often, students have become stuck down one track of attempted solution that isn’t working, and this questioning dialogue can help them change tracks. 

The main disadvantage of this method is that it is relatively time intensive – each student could require open-ended help to get to the point of understanding what needs to be done. A practical example of my approach to mitigate this time intensiveness is the Camberwell End Of Year Show. Students with wildly different needs and mediums are clustered in rooms across two large sites. Just doing a full sweep of the show alone would take 40 minutes. Therefore, I adopt what I call a layering or lacquering approach. This involves visiting each exhibition space in the same order, offering any necessary feedback and being open to practical and curatorial questions from students. Though small quick conversations, I will advance their issue along one step – for example if a student’s work is blocking an access route, I will indicate to them where it can’t be. Some issues I will hand over to a colleague via text – for example ‘can you bring an extension lead to 304 for the sculpture student there’ – and tell the student a colleague will deliver one. I will then complete my sweep of the whole site and start agin, checking in with the students again and offering any new feedback as needed. Eventually, through this lacquering process, rooms are ticked off as ‘done’ on my exhibition spreadsheet, doing ever faster sweeps of outstanding spaces until the whole show is ticked off as ‘done’. This method is essentially working in parallel as much as possible, with students doing the time-intensive work while you’re not there, enacting one’s feedback. It also allows for checking if student’s have understood the feedback easily – you’ll likely be speaking to the same student within two hours on the next sweep, so if they have misapplied the feedback then not too much of their or your time has been wasted, and a new round of questioning can begin. 

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *